General Specifications As Per Brochure
           
           Max. Pressure:                           100 Bar
           
                                                    1500 PSI
           
           Coolant Volume:                          Automatically Variable
                                                    36 - 180 Liters / Minute
                                                    9 - 48 GPM
           Tank:                                    900 Liter / 240 Gallon
           Filtration:                              Triple Parallel Bags
           Outlets:                                 3
           
           The WV3-180 can operate as three completely independent 60 liter (16 gpm)
           modules or combine to give you high pressure AND very high volume (180
           liters) to one outlet at any time during the same program!
           
           
           Standard Configuration:
           The ChipBLASTER WV3-180 is fed by a transfer pump that draws from the machine
           
           tool sump, through the filter vessel to the integral 900 liter (240 gal) tank.
           
           When the machine tool calls for coolant, the filter pump(s) draws the coolant
           
           from the ChipBLASTER tank and pumps through the post (safety) filter to the
           
           inlet of the positive displacement pump. The coolant then flows at high
           
           pressure through a series of distribution and safety valves and on to the
           
           machine tool.
           
           M Code Requirement:
             1 "M" Code Controlled Signal is Required to Operate as One High Volume
           
             Outlet.
             3 "M" Code Controlled Signals Are Required to Operate as Three Independent
           
             Modules
             4 "M" Code Controlled Signals Are Required to Operate as Three Independent
           
             Modules AND One High Volume Outlet.
           24 VDC,110 VAC or 240 VAC signal is acceptable needed
           * If your machine uses pulsed "M: codes, contact ChipBLASTER
           
           Required Electrical Power:
             106 amps, 230 VAC, 3 Phase, 60 Hz
             53 amps, 460 VAC, 3 Phase, 60 Hz
             64 amps, 400 VAC, 3 Phase, 50 Hz
           
           Ideal for Machine Tools Up to 90 Kw (120 HP), Dual Turret Lathes & 50 Taper
           
           Mills.
           
           See brochure for more details and options.
           
           
           

Automatics & Machinery Co Inc
150 Martin St Longmont CO 80501-5939
Tel: 800-543-7666 Fax: 303-651-6556
Email (Request Quote): sue@automatics.com
Web: www.automatics.com