Specification from OEM Brochure (All details should be confirmed by buyer)
          
          
          Equipped With 
          Face Plate 
          18" Bison 4-Jaw Chuck 
          3 Point Steady Rest 
          
          General Specification:
          Swing Over Bed                          18.1" 
          Center Distance                         55" (60" overall)
          Swing Over Cross Slide                  10.6" 
          Swing in Gap                            28.7" 
          Gap Width in Front of Faceplate         8.5" 
          Spindle Center High From Floor          45" 
          Width of Cross Slide                    8" 
          Type of Cross Slide Ways Dovetail 
          Bed Width                               15.7" 
          Type of Bed Ways V and Flat Ways 
          Coolant Tank Capacity                   25 Gallons 
          Spindle Nose                            D1-8 
          Spindle front Bearing I.D.              5.25" 
          Spindle Taper                           5 MT 
          Spindle Bore                            3.07" 
          Speed Ranges (Auto Selected)            3 
          Spindle Speed - Low Range               1 - 247 RPM 
          Spindle Speed - Medium Range            1 - 740 RPM 
          Spindle Speed - High  Range             1 - 2200 RPM
          
          Spindle Drive Variable AC 
          Spindle Motor (Cont./30 min)            10/15 HP 
          Min. Spindle Speed for Full Power       71 RPM 
          Power Consumption                       26 KVA 
          Cross Slide Travel (X Axis)             11.7" 
          X Axis Rapid Traverse                   315"/min 
          X Axis and Z Axis Feed Rate             .0012" - 236"/rev. 
          X Axis Thrust (continuous)              1,464 lbs. 
          X Axis Ballscrew                        25 x 4 mm 
          Saddle Travel (Z Axis)                  55.0" 
          Z-Axis Rapid Traverse                   394"/min 
          Z Axis Thrust (continuous)              2,196 lbs 
          X Axis Ballscrew                        40 x 8 mm 
          Positioning Accuracy                    0.0002" 
          Repeatability                           0.0001" 
          Tailstock Taper                         6MT 
          Tailstock Quill Diameter                3.74" 
          
          
          
          

Automatics & Machinery Co Inc
150 Martin St Longmont CO 80501-5939
Tel: 800-543-7666 Fax: 303-651-6556
Email (Request Quote): kristen@automatics.com
Web: www.automatics.com