Model: KTM-3VKF
Table Size: 10" X 50"
Table Travel (X-Axis): 36"
Saddle Travel (Y-Axis): 15.75"
Knee Travel (Z-Axis): 16"
Quill Travel: 5"
Ram Travel: 20"
Spindle Motor: 3 HP (1750 RPM @ 60 HZ)
Power Requirements: 220/440 VOLTS, 3 PH, 60 HZ, 10/5 AMP
Spindle Speed: Variable 60-500-4200 (2 RANGE, HI/LOW)
Spindle Taper: R8 (NMTB-30 AVAILABLE)
Quill Diameter: 3.375"
Quill Feed Rate: 0.0015/0.003/0.006" PER REV
Drilling Capacity (Manual): 0.75" Diameter
Drilling Capacity (Power): 0.37" Diameter
Boring Capacity: 6.0" Diameter
Milling Capacity: 2.0 IN3/MIN
Max. Work Load (Center): 850 lbs.
Machine Weight (Approx): 3250 lbs.
Skid Dimensions: 72" X 72" X 84"H (Skid)


FEATURES:
* 3HP spindle motor wiht electronic variable speed (EVS) AC-
frequency drive milling head. NOTE: The AC-Frequency drive
can accept single phase power at 50% reduction in output of
HP....this is ideal where only single-phase power is
available.
* Table, Saddle, and Knee Hardened & Ground
Dovetail Ways
* Precision ground leadscrews with backlash compensating
double nut
* Precision bored and ground miling head, with super
precision ABEC-7 bearings
* Meehanite castings, with built-in coolant reservoir in
machine base
* Centralized one-shot lubrication, with metered check-
valves

OPTIONAL ACCESSORIES:
ACU-RITE DRO System (2-axis, 0.0002"
resolution)
Table Power Feed (X-AXIS)
Saddle Power Feed (Y-AXIS)
Knee Power Feed (Z-AXIS)
Air Power Drawbar (maxi-torque)
Flood Coolant System
Prolong Ultra-Cut Coolant (2.5 Gallons)
Riser Block (4")
Riser Block (6")
Riser Block (8")
Angle-Lock Vise (6")
Angle-Lock Vise (8")
Rotary Table (12", Vertical & Horizontal)
Clamping Kit
R8 Collet Set (11 PC., 1/8" TO 3/4")
DRO Installatoin charge

Scott Machinery Inc
4700 Lang Ave, Suite D McClellan CA 95652-6215
Tel: 916-638-7718 Fax: 916-638-2450
Email (Request Quote): sales@scottmachinery.com
Web: www.scottmachinery.com