MAKE: DAKE
MODEL: LE 10A
Machine Type:Horizontal scissors type
Capacity: Bundled 4-½ inches – 7 inches wide, 5-½ inches high
Drop Length Possible:Less than 2 inches
Blade Size:138 inches x 1 inch
Blade Speeds (Feet Per Minute):88 / 130 / 177 / 223 / 262
Feed Stroke (Single): 3/8 inch minimum - 16 inch maximum
Multiple Stroke: 9 times (142 inches maximum)
Feed Type: Hydraulic hitch feed with vertical rollers, feed speed 16 inches in 6 seconds
Length Set Up: Front mounted hand wheel, and DRO with large numeral digits.
Horse Power Blade Motor: 3 H.P.
Hydraulic Pump: 1 H.P.
Coolant Pump:Gear type – 1/8 H.P.
Hydraulic Oil Cap.: 5-¼ gallons
Coolant Cap.:10 gallons
Vises: (Quick set ratchet type)Hydraulic with blade forward clamping for minimized burr and with 1” throw
Vise Clamping Pressure:600 pounds
Vise Ways: Precision ground and hardened
Work Table: Machined with chip clearance inserts
Hitch Feed Capacity: 2790 pounds with use of roller table
Hydraulic Pump:Hydraulics on demand (HOD) with minimum pressure start up
Head Feed:Hydraulic regulation with RPM compensation feed back
Piece Counter:9999 piece with auto shut off
Rapid Head Approach:Sure stop hydraulically controlled
Blade Tensioning:Mechanical with preset locking ring
Electrical: CE approved / Thermo overload, low voltage protection, 110 control voltage
System Control:PLC
Warning Light:Yes
Auto Shut Off:Pieces reached, out of stock, blade slippage/breakage
Chip Brush:Speed synchronized
Foot Print:76 inches x 69 inches (145 inches deep without roller support)
Roller Support with Vertical Roller Dimensions72 inches long x 16 inches wide
Work Height:21-½ inches
Weight:2645 pounds
Tool Kit:Standard – Includes screw drivers, wrenches and Allan keys
Spare Parts:Standard – Includes chip brushes and guide bearing replacements
Work Light:Standard
Machine Support Pads:Standard
Collective Hour Timer:Standard
Auger Style Chip Removal System: Standard
Guarding:Full hinged
Lubricant:Flood type unit built into the machine (Electric)
Voltage· Available 230-volt three phase · Available 460-volt three phase (external transformer)Machine should be wired to main service by a qualified Electrician.
AMP· 20-amp service for 230-volt machine· 16-amp service for 460-volt machine
Compressed Air:N/A (Clean, dry)
Operating Temperature:No special operating temperature level

Nevins Machinery Concepts Inc
820 Pearl St Brockton MA 02301-4411
Tel: 508-894-0008 Fax: 508-583-1528
Email (Request Quote): sales@nevinsmachinery.com
Web: www.nevinsmachineryconcepts.com