AGE: N/A

SPECIFICATIONS:

Material Type: Hot Rolled, Including High Strength G80
Max. Shear Strength: 80,000 PSI
Incoming Coil Width: 20" Min., 72" Max.
Max. Nominal Coil Width - Entry: 74"
Coil Weight, Entry & Exit: 70,000 Lbs.
Thickness Range: .062" to .625"
Min. Coil OD, Exit: 30"
Max. Coil OD, Exit: 24" (at Recoiler)
Coil ID, Entry: 18" to 33"
Coil ID, Exit: 24" (at Recoiler)
Max. Line Speed, Low Gear: 0 to 150 FPM
Max. Line Speed, High Gear: 0 to 400 FPM
Threading Speed: 15 to 100 FPM
Slitting Capacity, 80,000 PSI Shear Strength w/10.5" Arbor,

Low Gear: 3 Cuts of .625"
5 Cuts of .500"
11 Cuts of .250"
Cropping Shear Cycle: 10 Cuts per Minute
Electrical Supply: 480/3/60, AC to DC, All DC Motors 0 to

500V Modern (Should be Baked & Checked

before Using)
Air Supply: 80 PSI
Mode of Operation: Loop or Helper Drive
Line Direction: Right to Left
Pay-Off Direction: Over Unwind
Rewind Direction: Over Rewind
Inspections Equipment w/X-Ray Gauge, Digital Length

Measurement

EQUIPPED WITH: Floor Type Coil Car
Double-End Cone Uncoiler w/Large Wichita Double

Air Brake System, Dual Power Rotation
Hydraulic Hold Down Roll System
Peeler System, In/Out, Up/Down
Flattener Entry Pinch Rolls: 12" Dia. x 78"

Face Width
Flattener Work Rolls: 78" Face Width
Entry Butech Crop Shear, Large Edge Guide

Assembly
Slitter w/DC 500V Motor, AC to DC Controls,

Modern SCR Drive w/Controls, Quick Removal

Ejector Type w/Two Slitter Heads w/Hydraulic

Clamping, 10.5" Dia. Arbors, 200 HP DC Drive

for Loop or Helper Drive Slitting, Large

Complement of Cutters, Spacers & Rubber

Strippers
(2) New Heavy Duty Hydraulic Self Ejecting

Scrap Winders w/Level Wind for .625" x 3" Edge

Trim - OPTIONAL FOR ADDITIONAL COST
New Hydraulic Clamp & Drum Insert Device -

OPTIONAL FOR ADDITIONAL COST
Recoiler w/Dual Hydraulic Snubber, Overarm

Separator, 24" Dia. x 84" Face Width x 70,000#

Cap. Drum, 13/16" Wide Gripper Slot w/Hyd.

Expansion, 2-Speed System, 150 & 500 FPM,

Modern 200 HP, 500V, 500/2000 RPM DC Motor
Hydraulic Push-Off
Pit Type Coil Car w/Rolls for Side Roller

Conveyor Feeding
All Electrical, Including All Control Consoles,

Large Control Cubical w/Fuses, SCR Drives,

Pre-Wired
All Hydraulics, Including Several Pump & Tank

Units w/Many Solenoid Valves, Manifolds,

Piping, Hoses

Condition: EXCELLENT, As Taken From Service

Bass Machinery
2100 Hendon St Toledo OH 43606-4543
Tel: 419-243-2277 Fax: 330-299-0520
Email (Request Quote): sales@bassmachinery.com
Web: www.bassmachinery.com