General Specifications As Per Brochure
           
           Bar Capacity:
              Round:                               1/2" - 4-1/4"
              Hex:                                 3-3/4"
              Square:                              3"
           Bar Height:                             41"
           HP:                                     3
           RPM:                                    360
           Min. Part Length:                       18"
           Mach. Width:                            41"
           Mach. Length:                           40"
           Weight (Approx):                        530 lbs
           Equipped with (must be verified by buyer):
              30 degree Chamfer tool standard w/3/4" square 8 sided carbide insert
              3-jaw chuck.  Chuck & bar remain stationary, the cutter revolves around
                the bar.
              Single speed positive drive gear box (no blets to slip or adjust)
              230/460 volt, 3 phase, 60hz motor & switch
              Adjustable bar & slide stops for consistent chamfering
              Ball bearing ways
              Removable chip pan
              Bar support stand
           Optional Equipment
           
           ** Prices subject to change without notice ***
           
           Air Operated Chucking (Actuators, Valves, & Brackets Included) $1,695.00
           Variable Speed (AC Inverter with 3 HP Motor) (58 - 700 R.P.M.)
           For deep chamfers on hard or difficult to machine materials ...$1,450.00
           Mist Spray Coolant System (May be recommended for deep chamfers on
           difficult to machine materials) ...............................$  445.00
           Cutting Oil Drip System+
           (For deep chamfers on difficult to machine materials) .........$  695.00
           Square Stock Adapter (Up To 2") (One Needed For Each Dia) .... $  325.00
           Castors .......................................................$  895.00
           Additional Bar Support Stand, 2,000 Lb. Capacity ..............$  235.00
           
           Turn and Chamfer Toolholder (#5279) with Inserts 
            (Fits in Standard Cutterhead)................................ $  425.00
           -Replacement Inserts (TPMT 3252MF) .....................(each) $   29.00
           Additional 30-Degree Chamfer Toolholder (#5069) 
            with 3/4" Carbide Insert .....................................$  345.00
           -Replacement 3/4" insert for #5069 Toolholder (SNMP-643) ......$   27.00
           -Replacement Insert Screw for #5069 Toolholder (0530641) ......$   16.50
           Tube Head Assembly (For simultaneous ID & OD Deburring and Facing
           of Tubing) This Clamps Into the standard 300-1 series cutterhead
           (ID, OD, and Facing Cartridges & Inserts included) ............$  975.00
           Special Toolholders (Alternate degree chamfer, Special length Turn and
           Chamfer, Chamfer and Face, etc.) ..............................   Quoted
           Heat Treated crate for Int'l Shipments ........................$  625.00
           
           
           
           
           

Automatics & Machinery Co Inc
150 Martin St Longmont CO 80501-5939
Tel: 800-543-7666 Fax: 303-651-6556
Email (Request Quote): sue@automatics.com
Web: www.automatics.com